en:newbie:configuration_eyebeam_soft_phone [asterCC, hosted call center solution based asterisk]

Translations of this page:

This is an old revision of the document!

After the extension is established, then we need to configure the softphone, until soft phone registered successfully to achieve internal calls。

SIPAccount settings

SIP account settings, right-click eyebeam interface, click the SIP Account Ssttings, click the Add button to add a SIP account

SIP account that corresponds to the SIP extension equipment, add a type system into the system, open the Device Manager page, double-click a device record to open the following interface:

The red font identifies the correspondence between the corresponding item in the eyebeam SIP account settings in the device information,

Displayname: Fill in the caller name

User name: fill in the identity of the extension

Password: Fill in the password of the extension

Domain: fill in the system within the IP address

Click OK to submit set

**eyebeam than the xlite advanced eyebeam support multiple accounts, xlite only supports one account for telephone service processing.

You can select the desired account in the account before the check, and are free to choose the “Add” button to add a new account.

eyebeamAlso support the g729 coding

After the submission of such a normal registration, display Ready

* Common functions keys

So that soft phone configuration is successful, according to the need to use the soft phone outbound, inbound, and intercom.

Can directly dial other extension number, incoming caller information pops up.

**Continue to understand Configure the ring group **

en/newbie/configuration_eyebeam_soft_phone.1328606472.txt.gz · Last modified: 2017/12/12 03:11 (external edit)

Show pagesource Old revisions

Backlinks Back to top