When the outbound call trunk matches the trunk the system rate assigned, and the number dialed matches the rate rules, the system will carculate the cost of this call via the matched rate, and add up to the call cost of the trunk and the system.

Click Rate–>System rate, and it shows the current system rate list

Click “Add” to add a new piece of rate.

• Prefix：the prefix of the called number which matches this rate. E.g., “0” for domestic long-distant dials, “00” for international numbers, “001” for Amrican numbers, “default” for any number.

• Billing block： how often it bills.

• Status: enable or disable the rate control.

• Length：We can rule by setting the length of the number, and “0” for no restriction.

• Destination: name this rate, for example “local calls”, “long distant calls” or “American”

• Connect charge: the rate once the call is connected

• Init block: the duration for the connect charge

• Rate: rate per minute

• Team: the team this rate applies to. If leave it blank, this rate would apply to all teams. And during use, the system would priorly find the assigned rate of the team, and if nothing is found, then it will search for the unassigned rate.

• Trunk: the name of the trunk this rate applies to

Double click a rate to enter the edit page.